Publicidad
Idiomas disponibles
Idiomas disponibles
C
2. VARIABLE SPEED CONTROL (SEE FIG. D)
Select oscillation frequency (speed) while the
motor is running.
The variable speed control (4) can be used to
set the optimum oscillating frequency according
to the accessories used and the respective
application.
High oscillation frequency: Sanding, sawing,
C2
rasping and polishing stone and metal.
Low oscillation frequency: Polishing varnishes.
D
C3
3. SELECTING AN APPLICATION TOOL (SEE
FIG. E)
Please observe the application tools intended for
your machine. Do not use these application tools
are not intended for this machine.
E
C2
C4
WORKING HINTS FOR
YOUR OSCILLATING
C3
TOOL
1. If your power tool becomes too hot, especially
when used at low speed, set the speed to
maximum and run it with no load for 2-3
C2
minutes to cool the motor. Avoid prolonged
usage at very low speeds. Always keep the
blade sharp.
2. Always ensure the workpiece is firmly held or
clamped to prevent movement. Any movement
of the material may affect the quality of the
cutting or sanding finish.
3. Start your tool before working and turn it off
only after you stop working.
4. Do not start sanding without having the
sandpaper fitted.
5. Do not allow the sandpaper to wear away, it
will damage the sanding pad. The guarantee
does not cover sanding pad wear and tear.
6. Use coarse grit paper to sand rough surfaces,
medium grit for smooth surfaces and fine grit
for finishing surfaces. If necessary, first make
a test run on scrap material.
7. Excessive force will reduce the working
efficiency and cause motor overload.
8. Replacing the accessory regularly will maintain
optimum working efficiency.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication
or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a
hazard.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local authorities or retailer for recycling
advice.
29
Publicidad
