Publicidad
Fig. 25b
steering wheel
flat washer
loc nut
spacer
steering wheel cap
Fig. 25c
metal strap
Anchor-It
Steering Wheel
Carriage Bolt
Anchor-It
W. Anchor-It Installation.
n n s s t t r r u u c c t t i i o o n n s s f f o o r r A A n n c c h h o o r r i i n n g g S S w w i i n n g g • • N N • • S S l l i i d d e e A A c c t t i i v v i i t t y y
I I
C C e e n n t t e e r r s s
1. Determine the final location of your activity center.
2. Place the Anchor- It stakes adjacent to the base and near
Flat Washer
the corners of your activity center (at the bottom of the legs
on swing sets) and twist the auger- style stakes into the
ground until only the loop is exposed.
1-1/2"
3. Place the metal strap through the loop of the Anchor- It
lag bolt
stake and secure it to the unit with a lag screw and washer
as illustrated to the right. Note: Attach the strap to the unit
with as little play as possible using whatever holes in the
strap that work best.
39
Brentwood Assembly Instructions
V. Steering Wheel Installation.
1. Choose a desired location for the
steering wheel and drill a 3/8"
diameter hole through the lumber.
NOTE: If lumber is greater than 2"
in depth, you will need to
counterbore the hole appropriately.
2. Mount steering wheel to climbing
unit as indicated in (Fig. 25b).
3. Snap steering wheel cap into place
(Fig. 25b).
Publicidad
