Ford LJ98-10C823-AC 48A Manual De Instrucciones página 8

3. Remove the coupler from the remote dock.
4. Plug the coupler into the vehicle charge port until it
clicks. The charge station should indicate that the ve-
hicle is establishing a connection to the charge station
( ).
5. As soon as the vehicle and charge station are con-
nected, the charge station indicator exhibits one of
the following states:
6. The charge station will be in standby (
if the vehicle is fully charged or scheduled to charge
later.
7. The charge station will begin charging (
).
5.2
Stop charging
You will generally end a charging session when charging is
complete (indicated by the charge station status indicator
being in standby state ( ), but you can also in-
terrupt and end an incomplete charging session.
To stop a charging session:
1. Unlock and remove the coupler from the vehicle press-
ing the coupler button (typical in North America) or
follow the vehicle direction to disengage the vehicle
lock on the coupler (typical in Europe). The charge
station should return to Power On state
( ).
2. Close the vehicle charge port cover.
3. Wrap the loose cable around the remote dock.
4. Plug the coupler into the remote dock.
5. Lock ( ) the charge station if desired.
5.3
Features
Features available (see the FordPass app for functions and
uses)
– Access Control (lock/unlock)
– Charging Insights
– Maximum Charge Current Setting
– Station Sharing
This product will continue to evolve and new features will be
released over time.
8
l The charge station is capable of over-the-air firmware
updates when connected to the Internet through Wi-Fi.
l The charge station does not require Wi-Fi to charge your
vehicle, but Wi-Fi does enhances its capabilities.
If there is an Internet connection, the Ford Connected
Charge Station will perform automatic software updates.
Please note that the HMI display will cycle through different
animations including a solid red light (see example below).
Updates may take 10-15 minutes.
)
5.4
Status indicator
State Status Description
indicator
Unpow- Off
ered
Power On Blue, center
single LED,
solid
Standby Blue, full bar,
solid
Charging Blue, full bar,
pulsing
Locked Blue, center
single LED, in-
termittent
LJ98-10C823-AC 48A
State Status
indicator
Plugging
In
Update/
Reboot-
ing
Self-
Check
mode
Charging
Reduced
(Over-
heating)
Station
Error
State
Explanation Station
fault
The charge station is
Station
not powered.
Electrical
The charge station is
fault
powered and unlocked
Unplug
(default state).
The charge station is re-
ceiving power and is
ready to charge the ve-
hicle.
Table 1: Status indicator
The charge station is
successfully charging
the vehicle.
The charge station is
powered and is locked
and will not charge until
unlocked.
Ford Connected Charge Station Operation Manual
Description Explanation
White, full bar, The charge station is
cycling to mid- connecting to the vehi-
dle cle, preparing to charge.
White, wipe The charge station is
left to right downloading firmware
or rebooting after
changes to settings.
White, full bar, The charge station is
solid checking that all status
indicators are working.
Amber, full The charge station is
bar, solid charging at a reduced
background. rate due to overheating.
Blue, center,
pulsing
Amber, full The charge station has
bar, solid a fault and requires
troubleshooting. See
the app for details.
Red, full bar, The charge station has
solid experienced a non-re-
coverable fault.
Red, full bar, The charge station has
blink experienced a ground
fault.
White, full The EVSE (electric vehi-
bar, solid cle supply equipment)
is being disconnected
from the vehicle (a few
seconds).