Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Place the glasses upside down.
•
Place the cutlery in the cutlery baskets with the handles downwards. The different pieces of
•
cutlery can be mixed.
Place the cutlery baskets in the lower baskets.
•
5.1.5 Selecting the wash cycle
Before starting the wash cycle, place the corresponding basket containing the dishes in the machine.
Before starting the wash process, the position of the control switch must be changed, or the pre-
selected wash time is maintained when the machine is switched on. Then close the door and press
the start cycle button.
The door must be closed for the machine to start the wash cycle. For safety reasons,
if the door is open, the wash cycle will not start.
5.1.6 Thermo-stop
The machine you have purchased is not fitted with the thermo-stop function. This is only fitted in
higher ranges.
5.1.7 Stopping the wash cycle and end of wash cycle
The wash cycle can be stopped in the following ways:
By switching off the machine → the cycle stops completely.
•
By opening the door → when the door is closed, the cycle continues.
•
At the end of the wash cycle, remove the basket and leave the dishes to dry naturally. Remove the
dishes from the basket with clean hands, taking care not to burn yourself as the dishes are extremely
hot.
5.1.8 Cold rinse (only OEM-400 MOD. and versions)
The machine you have purchased has a cold rinse system so that once the tableware has been
washed, it can be cooled quickly ready for subsequent use. To activate the cold rinse system, turn
the control button to cold rinse (G) and hold down for the required time.
5.1.9 Drainage of the machine
The dishwashers have two types of drainage; gravity drainage or using a drainage pump.
5.1.9.1 Drainage by gravity
To drain the machine in this way, just remove the overflow from the machine and it will drain
naturally. For reasons of safety, this method of drainage should only be used with the machine
switched off.
5.1.9.2 Drainage using the drainage pump (optional)
The drainage using the drainage pump option is only available on request. The drainage pipe must
always be fitted on a siphon to prevent the return of odours.To drain the machine using this method,
proceed as follows:
Remove the overflow valve.
•
Select the drainage function on the selector switch (H).
•
Close the door and press the start cycle button (D), the drainage cycle will start
•
automatically.
At the end of the cycle (approx. 160 s), replace the overflow valve. The machine may be
•
switched off.
5.1.10 Switching off the machine
The dishwasher is switched off by turning the selector switch to 0.
The machine should not be switched off during the wash process as this will stop the tableware
inside the machine from being cleaned properly.
5.1.11 Cleaning the machine at the end of the day
At the end of the day, the filters, wash distributors, rinse branches and other accessories must be
cleaned. This is necessary to prolong the service life of the machine. To ensure the efficient washing
of the dishes, the dishwasher must be perfectly clean and disinfected.
5.2 Useful tips
Read the useful tips listed below carefully to allow you to get the most out of your dishwasher.
38
To drain the machine with the drainage pump, the hose must be at a
height (max. 680 mm).
Publicidad
