brondell CIRCLE RC100 Manual De Usuario página 13

STEP 3: DRAIN CLAMP INSTALLATION
WARNING: this step may require drilling into the existing drain pipe. Please seek
professional help when completing this step and always wear safety protection including
safety goggles!
1. If there is an existing drain connection for a 1/4 inch quick connect tube, then use this connection.
Otherwise, locate a suitable area on the sink drain pipe to install the provided drain clamp.
NOTE: Select a location for
the drain hole based on the
design of the plumbing. It
should be installed above the
trap and on the vertical or
horizontal tail piece. Locate
the drain connection away
from the garbage disposal.
See example to the right.
2. Once a suitable spot has been selected for the drain clamp,
drill a 1/4 inch hole into one side of the pipe. Be sure to use
a suitable drill bit for the material being drilled into (for
example: PVC versus Metal Pipe) and be sure to use safety
goggles.
NOTE: Starting with the 1/8 inch drill bit, drill a 1/8 inch hole
in the drain pipe. Use the 1/4 inch drill bit to enlarge the hole.
If you do not have a 1/8 inch drill bit, then you can just use
the 1/4 inch bit. Clean the debris from the pipe and the hole
before continuing.
DO NOT drill all the way through the pipe.
1
MOUNT
DRAIN VALVE
HERE
2
11