Publicidad
Idiomas disponibles
Idiomas disponibles
Step 3: Attach the cart rear panel (6).
Insert screws (A) into the cart left side panel (4) and the cart
right side panel (5). Do not fully tighten screws (keep
approximately 4 to 6mm slack). Align the key holes in the
cart rear panel (6) with the two screws just installed into the
cart left and right side panels. Push cart rear panel (6) over
screws, then slide down to meet bottom shelf (1). Secure the
cart rear panel (6) to the bottom shelf (1) with 3 screws (A).
Tighten the 2 screws on the cart left and right side panels
(4 & 5).
Hardware Used
A
M6x12 Screw
Step 4: Install the upper front door brace (7).
Install two screws (A) into the cart left and right side panels
(4 & 5) as illustrated. Do not fully tighten screws (keep
approximately 4 to 6mm slack). Align the key hole slots in
the upper front door brace (7) with the 4 screws just installed
into the cart left and right side panels (4 & 5). Slide the upper
front door brace (7) in and down until snug. Tighten the 4
screws (A).
Hardware Used
A
M6x12 Screw
Qty: 5 pcs
Qty: 4 pcs
9
5
6
A
A
7
5
5
Publicidad
