Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
No gas flow or an
obstructed gas flow.
The burner will not
light using the
ignitor procedure
(weak or no spark
being generated).
Possible Causes
• Tank valve not on or fully opened.
• Empty tank.
• Poor connection between valve
regulator and LP cylinder
coupling.
• Burner inlet blocked.
• The ignition electrode may be
covered with grease or residue.
• The ignition electrode may have
a loose or disconnected wire.
• Cracked or broken ignition
electrode.
• Dead battery or faulty battery
connection.
• Fully open tank valve by turning
counterclockwise
• Check fuel level and replace
fuel if necessary.
• Turn off grill knobs, close the LP
cylinder value at top of cylinder
and check the connection
between the regulator valve
and cylinder coupling.
Disconnect and reconnect, if
necessary.
• Clean the burner inlet (venturi)
and burner as described by the
Care and Maintenance section
in the Manual.
• Turn control knobs to the off
position and clean the ignition
electrode with rubbing alcohol
and cotton swab.
• Check the connection and
reconnect any loose or
disconnected wires.
• Replace ignition electrode (see
Replacement Parts List).
• Perform any of the following:
a. Replace battery
b. Check to see if battery is
c. Check for any corrosion
d. Check wire connections as
26
Possible Solutions
inserted correctly.
around battery terminals.
stated above.
.
Publicidad
