Melchioni Family MILKY Manual De Instrucciones página 18

 Read this manual in its entirety, paying particular attention to the instructions for safe
use.
 Carefully remove all possible fastening materials from parts, including internal parts.
 Fully remove any stickers from the surface of the appliance.
 Place the appliance on a flat, stable surface, taking care to reserve 10 cm of space on
all sides, at the rear and above the appliance for the necessary air circulation.
 Refer to chapter 2 for further details and instructions on appliance positioning and
installation.
 Wash the container and impeller in lukewarm water with normal dish soap. Rinse
properly and wait until completely dry before proceeding further.
 Place the base on a flat and stable surface.
 Ensure that the cord does not come into contact with hot parts and that it is not
subjected to excessive bending or kinking.
 Remove the impeller from the lid, pulling it gently and continuously
 Place and push the impeller into the shaft on the bottom of the
container until it stops. It may need to be slightly rotated to align the
impeller with the shaft for best assembly.
 Pour milk into the container between the MIN and MAX levels.
 Place the container on the base.
 Connect the power cord to an electrical outlet.
 Start the "Heating and soft froth" program.
 When rotation stops, wait 30 seconds and discard the preparation.
 The appliance is now ready for subsequent use.
5. USING THE APPLIANCE
The appliance is designed to heat drinking milk and possibly froth it to a soft and airy, or
else dense and compact froth. Once the appliance has been assembled and the
container filled, as explained in the previous chapter, select the desired program by
pressing the FUNCTION button (6) repeatedly until the LED indicator corresponding to
the desired program lights up, as per the following table:
Symbol Function
Heating only
Cold frothing
Capacity Description
This function heats the milk without frothing it.
Minimum rotation is guaranteed to avoid the
75 – 300 ml
formation of lumps, uneven heating or overheating
of the protein component.
This function can be used to create a silky foam on
75 – 150 ml top of the milk, without heating it. It can be used
with milk and coconut milk.
17