Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
To set the cutting height:
■ To raise the cutting height, grasp the cutting height adjustment lever, disengage the lever from
its current setting, and then move it towards the back of the mower and engage the lever in the
desired cutting height position (Fig. 8).
■ To lower the cutting height, grasp the cutting height adjustment lever, disengage the lever from
its current setting, and then move it towards the front of the mower and engage the lever in the
desired cutting height position (Fig. 8).
Starting/Stopping the Mower
NOTE: Use only an approved outdoor extension cord as described previously in this manual.
■ Attach the outlet end of an extension cord to the mower's power inlet. Make a loop in the
extension cord and hang the loop onto the cord retainer (Fig. 9).
■ Connect the machine to a suitable po¬wer supply.
■ Before switching the mower on, make sure that the working area is free from debris and foreign
objects.
■ Press and hold the safety button. Pull the switch lever towards the mower handle and hold in
position (Fig. 10).
■ Once started, release the safety button. Continue to hold the switch lever against the mower
handle as you mow.
■ To switch the mower off, re¬lease the switch lever.
NOTE: A high-pitched noise and sparking may occur as the electric motor decelerates. This is
normal.
WARNING
The blade may keep rotating for a few seconds after the device has been switched off. Do not
touch the rotating blade. A rotating blade can cause injury.
General Operation
Check the product, its power cord and accessories for damage before each use. Before use,
ensure all power connections are in good working order prior to operation. If damage is present or
observed, stop and have mower serviced before use. Do not use the product if it is damaged.
■ Double check that the blade is properly installed.
■ Always hold the product by its operation handles. Keep handles dry to ensure safe support.
■ Ensure that air vents are always unobstructed and clear. Clean them if necessary with a soft
brush. Blocked air vents may lead to overheating and damage to the product.
■ Switch the product off immediately if you are disturbed while working by other people entering
the working area.
■ Always let the blade come to a complete stop before removing the grass collection bag/
63
DE
Publicidad
