Panadero P65 Manual De Instalación Y Mantenimiento página 28


Stainless steel hose clamp.

T of 135° with outlet.

Elbow of 45°.

Wooden ground.

Non flammable floor protection.

Stainless steel flexible tube.

Rigid flexible pole adapter.

Minimum 200mm.

It must exceed roof height by 1 metre.
If the tube over 4 m in length, the next larger

size will be used.
4.26. Installing in a brickwork chimney can be done using flexible piping in its entirety, as indicated in drawing 7.
We must take special care when sealing the chimney and gas venting to avoid gas blowing back during
storms.

Stainless steel hose clamp.

T of 135° with outlet.

Elbow of 45°.

Wooden ground.

Non flammable floor protection.

Stainless steel flexible tube.

Rigid flexible pole adapter.

Anti blow-back seal.

Minimum 200mm.

It must exceed roof height by 1 metre.
If the tube over 4 m in length, the next larger

size will be used.
When installing a flexible tube for gas outlet, be careful that this is not in contact or close to the circuit board
or combustible material.
WI-FI ANTENNA CONNECTION, POWER CABLE AND ROOM THERMOSTAT.
The stove is supplied with a PANADERO box. This box contains the user manual, the installation and
maintenance manual, a power cable, a room sensor, a cleaning brush and a Wi-fi antenna.
The user has to attach the wi-fi antenna and module to the connection platform (check section 1 of the
tablet manual). The connection platform of the wi-fi antenna is supplied attached to the rear of the hopper.
The room sensor and power cable must be connected to the rear heaters, in the right-hand side of the stove.
27
Drawing 6
Drawing 7