RIDGID FLIP TOP AC9934 Manual Del Operador página 3

OPERATION
wARNING:
To reduce the risk of injury from unexpected tool
movement, check to make sure work support does not
rock, slide or move prior to use.
wARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict severe injury.
SET UP
See Figures 1 and 2.
 Extend both legs to their full outward position.
 Loosen height adjustment knob and adjust table height to
support the work piece. Tighten knob securely.
 For added stability, attach weighted objects to the hooks at
the base of the stand.
INSTRUCTIONS FOR OUTFEED SUPPORT -
PIVOT POSITION
(For use with saws and planers)
 Remove locking pin.
 Rotate the table so the arrow on the table top is pointing up.
 Align the stand so outfeed arrow matches the outfeed direction
of the workpiece. Place stand at a distance from the tool that
supports the workpiece during the cut.
 Place the locking pin in the upper hole of the table. This will
prevent the table from rotating when pushing a workpiece off
the back of the stand.
 Make the cut.
PIN
HEIGHT
HOLE
ADJUSTMENT
KNOB
LOCKING
PIN
WEIGHT HOOK
WEIGHT
OUTFEED DIRECTION
HOOKS
W E
I G H
T H
O O
K
Fig. 1
INSTRUCTIONS FOR LATERAL SUPPORT -
HORI ZONTAL POSITION
(For use as work support)
 Remove locking pin.
 Rotate the table until it is horizontal. Place the locking pin in
the lower hole in the table.
 Place the workpiece on the table with an equal amount of the
workpiece on each side of the stand.
LOCKING
STORAGE
See Figure3.
 Rotate the table so the arrow on the table top is pointing down.
 Place locking pin in the lower hole in the table.
LOCKING
PIN
3 - English
PIN
HOLE
PIN
WEIGHT HOOK
PIN
HOLE
WEIGHT HOOK
Fig. 2
Fig. 3