Publicidad
Idiomas disponibles
Idiomas disponibles
1. GENERAL INFORMATION.
WARNING: Please read and understand perfectly the present instruction before using the machine.
SIMA S.A. thanks you for your trust in our products and for purchasing the BENDING OR COMBINED
ELECTRICAL CUTTING/BENDING MACHINE.
This manual provides you with the necessary instructions to start, use, maintain and in your case, repair of
the present machine. All aspects as far as the safety and health of the users is concerned have been stated.
Respecting all instructions and recommendations guarantees safety and low maintenance. As such, reading
this manual carefully is compulsory for any person responsible for the use, maintenance or repair of this machine.
It is recommended to have always this manual in an easily accessible place where the machine is being
2. GENERAL DESCRIPTION OF THE MACHINE.
The STAR-16 GO and STAR-20 bending machines have been manufactured to bend flat and reinforced steel
bars used for construction and passive steel armatures for structural concrete. The bending operation is done in cold
using
mandrels to guarantee the bending interior diameter is conforming to the European norms.
Any other use of this machine is considered inadequate and can be dangerous. Thus, this is completely
prohibited.
•
The gear box is the main element of the machine. It is responsible for transmitting the needed energy
to carry out the steel bars bending.
•
The machine is operated by an electrical motor that passes the movement, by a transmission to the
bending mechanism in which the different mandrills are mounted.
•
The bending angle can be decided by inserting the pivot in the bending plate. For a more precise
bending, the ruler can be accurately adjusted by its handle.
•
The commands panel is endowed with polyester, electrical knobs easily identified by pictograms.
•
The machine is equipped with shutdown and backward movement buttons to facilitate its manoeuvre.
The emergency knobs on both sides of the machine can be used in case of danger or incorrect
manoeuvres.
•
The general bars bending manoeuvre is performed in low-voltage (24V) according to the European
standards.
•
The original equipment (bolts, mandrels bending square) is heat-treated to withstand the tough type
of work the machine performs.
•
The machine is furnished with a pedal to confirm and execute the manoeuvre, thus avoiding the
upper parts to be trapped while the machine is running.
•
The work area is protected by a safety guard to limit possible accidents. This guard is transparent to
allow observation of the material being bent, avoiding getting to the upper parts of the bending area.
•
The main function of the machine is based on making stirrups, hooks, overlaps, reinforcing rings,
anchors, fences and any polygonal figure using small-caliber rod up to 20 mm.
•
The machine is painted in oven with a highly resistance, anti-corrosion epoxy polyester paint.
•
The original, electrical equipment is in conformity with the EC safety norms.
Any use of the machine for applications other than those stated above is dangerous and therefore
strictly prohibited.
4
ENGLISH
Publicidad
