Technical data
Network connection:
Input power:
Flow rate Q max.:
Discharge head H
max.:
Pump pressure max.:
Immersion depth max.: 7m
Minimum water level
upon commissioning:
Hose connection:
Connection for tap
connector with internal
thread:
Length of retaining
cable:
Water temperature
max.:
Maximum particle size
(suspended solids that
can be sucked in)
Protection class:
Protection type:
Safety
The warranty claim shall lapse
where damages or injuries
occur as a result of non-obser-
vance of these operating instructions!
The manufacturer shall assume no
liability for consequential damages!
No liability shall be assumed for
property damage or personal injury
caused as a result of improper han-
dling or non-observance of the safety
instructions.
Explanation of signal words
The following signal words are used
in these instructions:
230 V ~; 50 Hz
400 watts
10000 l/h
7m
0.7 bar
50mm
½", ¾", 1", 1 ½" (13 mm,
19 mm, 25 mm, 38 mm)
at the connecting piece -
G 1 ½" (44.9 mm)
at the adapter - G 1"
(33.3 mm)
approximately 8 m
35 °C
Ø 5 mm
I
IPX8
Introduction / Safety
WARNING!
This signal symbol/word indicates a
hazard with a medium level of risk
that, if not avoided, may result in
death or serious injury.
CAUTION!
This signal symbol/word indicates a
hazard with a low level of risk that,
if not avoided, may result in minor or
moderate injury.
NOTE!
This signal word warns of possible
damage to property.
General Safety Information
WARNING!
TRIC SHOCK!
Faulty electrical installation or ex-
cessive system voltage can result in
electric shock.
Connect the power cable only if
the supply voltage of the power
outlet corresponds to the informa-
tion on the type plate.
Connect the power cable only to
a power outlet that may be easily
accessed, so that you can quickly
disconnect the power cable from
the power supply in the event of a
malfunction.
Only operate the appliance using a
power outlet with a protective con-
tact safeguarded with at least 16A.
Do not use the appliance while
persons are present in the water.
The power supply for the appliance
must be provided via a residual
RISK OF ELEC-
GB/IE/NI/CY/MT
19