Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
Swash Installation (Cont'd)
7. Connect the bidet hose to the seat
Connect the bidet hose to the water inlet
and hand-tighten to secure; take care not
to twist the bidet hose, excessively bend
it, or strip the plastic screw threads when
screwing the hose onto the bidet seat.
Step 7
8. Attach the bidet seat to the mounting
plate
a. Set the bidet seat flat on the toilet
bowl in front of the mounting plate.
Slide seat forward onto plate until it
clicks into place and is secure.
Step 8
b. If the seat does not align with the
front edge of the toilet bowl, remove
the seat by pressing the quick release
button, which is located on the right
side if you're facing the seat. When
the seat releases, slide it off the
mounting plate.
c. Loosen the bolts and slide the
mounting plate back or forth to
readjust the placement; reinstall the
seat and check the alignment to the
edge of the toilet bowl (you may need
to remove, readjust, and reinstall
multiple times).
d. When the seat is lined up properly,
tighten the bolts and reinstall the
bidet seat.
14
9. Connect the open end of the bidet
hose to the T-Valve
Step 9
10. Turn on the water supply
a. Open the main water supply valve
slowly and check for leaks.
b. Wait 5 minutes, check again and, if
there are no leaks, continue.
11. Plug the power cord into an electrical
outlet; nozzle will extend and retract.
NOTES: Make sure to only use a ground-
ed GFCI (ground fault circuit interrupter)
electrical outlet, as in the case of a short
circuit, a grounded GFCI outlet may help
prevent electric shock or injury.
If it is necessary to use an extension cord,
only use those rated for a minimum of 15
amps with a 3-wire extension cord and a
3-blade grounding plug.
12. Pair the remote control
a. Insert 3 AAA batteries (included)
into the remote within 5 minutes of
plugging the seat into a GFCI outlet.
b. After inserting batteries, a blue light
on the remote will turn on.
c. Press any button within 5 seconds
before light turns off. A melody will
play to confirm remote pairing.
d. Repeat the process if the remote did
not pair.
13. Follow instructions on page 19
for using the bidet seat. Follow
instructions on page 19 for using the
bidet seat.
Publicidad
