Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT OPERATION
Using the Swash: Getting Started
NOTE: The seat has a built-in skin
conductivity sensor. The wash
functions will not work unless the
sensor detects someone is seated.
To override the seat sensor, see
instructions on page 23.
Prepare for wash
Sit on the seat to ensure skin-to-seat
contact on the seat sensor.
Warm water wash
When ready to wash, press the Rear Wash,
Front Wash, or Strong Wash button on the
remote control once to initiate a wash.
The nozzle will perform a self-cleaning
rinse, extend into the toilet bowl, spray for
2 minutes, turn off automatically, retract,
and self-clean once again.
1. To activate the move function during
a wash, press the Rear Wash, Front
Wash, or Strong Wash button a second
time. This will initiate the nozzle to
oscillate forward and backward,
providing a wider wash spray range.
Press again to stop the move function.
2. While washing, users can adjust the
water temperature, pressure, and
nozzle position settings. See page 17
for details.
3. To stop the wash before the 2-minute
cycle ends, press the Stop button to
discontinue water flow.
Warm air dryer
Press the Dry button to activate the warm air
dryer. The dryer will run for 2 minutes and
turn off automatically.
1. While the air dryer is operating, users
can adjust the dryer temperature to a
comfortable level using the Dry Temp
+ and – button on the right side of the
remote control. The dry temperature
will be reflected on the 5 LED indicator
lights.
2. To stop the dryer before the 2-minute
cycle ends, press the Stop button.
Gentle wash
Auto settings within the gentle wash mode
are 40% softer than standard wash modes.
Gentle wash will begin a wash that includes:
•
full nozzle extension
•
water pressure set to level 2
•
front wash and oscillation for 1.5 minutes
•
warm air dry cycle for 2-minutes set
on level 2
NOTE: During a gentle wash cycle,
water pressure and dryer settings may
still be adjusted.
19
Publicidad
