Grammer HIGH PERFORMANCE LINEA & TOUREA Instrucciones De Manejo página 19

Before you remove the driver's seat, disconnect all plug-in connections between the seat and

the vehicle supply network and disconnect the battery supply. When you replace the plug-
in connectors, make sure they are tight (dust, water).
Screw connections must be checked regularly for tight seat. If the seat wobbles there may

be loose bolts or other faults.
If the seat is equipped with seatbelts, check them for correct function.

Seatbelts must be fastened before driving.

The seatbelts must be replaced after an accident.
Where seatbelts are fitted to the driver's seat, the seat and seat mounting must be checked
additionally by specialist personnel after an accident has occurred.
Retro-fitting of driver's seats with integrated seatbelts is only admissible after consulting the

vehicle manufacturer and with proper fitting by authorized workshops.
If you note that the seat does not function correctly (for example a defective seat suspension;

improper curvature of the lumbar support or damaged bellows), contact a specialist
workshop immediately to arrange for repairs to be carried out.
If you fail to do so, your health may be affected and the risk of accident increased.
Do not indent the bellows while there is load on the driver's seat.

– RISK OF CRUSHING –
Make sure that the interior of the driver's seat remains free of foreign particles or liquids.

The driver's seat is not water-tight and must be protected against splashes of water!

Any conversion or retrofitting on a driver's seat made by GRAMMER AG must be performed

exclusively in authorized workshops by trained or suitably qualified personnel and in
adherence with the applicable operating, maintenance and installation instructions and in
compliance with all relevant national regulations.
Improper installation and assembly bear the risk of personal injury or property damage

and the proper function of the driver's seat or mounted parts can no longer be guaranteed.
The driver's seat is free of maintenance. Worn parts such as rollers, absorbers and the

fixation must be checked from time to time. If the driver's seat is not adjusted to the medium
position in case of load, the system pressure at the supply line or the function of the control
valve for medium position adjustment have to be checked.
Correct functioning of the driver's seat is essential to your health. Therefore, take adequate

care of your seat to ensure that it functions correctly.
To ensure proper function of the driver's seat and to prevent damages of the pneumatic

spring, adjust the loaded driver's seat to the highest height position (see "Height adjustment")
after it has been fitted into the vehicle. Please make sure that the normal working pressure is
available in the vehicle's air supply system. In case of non-observance, the guarantee will
expire.
Before driving, you must check if all seat settings selected guarantee a safe operation of

the vehicle.
Safety instructions
19