AQUA DELLA HI- TECH AQUAFILTER 80 Instrucciones De Uso página 2

EN
INSTALLATION:
Clean the glass of the aquarium where you want to install the
1
assembly plate.
Attach the assembly plate accordingly so the air vents can be
2
fixed 1 cm under water level (this produces the best surface flow).
Slide the rear side of the filter onto the top of the assembly plate.
3
Plug in the filter.
4
OPERATION:
Adjust the streaming direction with the twistable air vent.
1
Use the enclosed air hose if you want to enrich the water with oxygen. For this purpose
2
take off the rubber cap of the hose on the upper side of the filter.
Adjust the pump and filter capacity with the sliding switch.
3
CARE AND ATTENDANCE:
Pull power plug.
1
Take the filter out of the aquarium by pulling it upward – the
2
assembly plate can stay in.
Disconnect the filter from the pump and rinse carefully with cold
3
water or replace.
Attention: Do not change water and clean the filter at the same
time.
PA01-03-003-01_AQUADELLA_AQUAFILTER_MANUAL.indd 2
1 2
1.
2.
1.
2.
3
2.
1.
2
3
2
05-06-18 14:05