Descargar Imprimir esta página

Shop-Vac 92L400B Manual De Usuario página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

TOP HANDLE
If the top handle is not installed on your unit, align holes in handle and holes in motor
cover and secure with screws provided.
CASTER SYSTEM
Follow the instructions for the caster system that came with your vacuum.
PLASTIC TANK WITH CASTER FEET
You will find four caster feet, four casters and four screws with your vacuum. Assemble as
follows:
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down
so that bottom is facing up.
2. With front of tank facing you, take caster feet marked with the
letter A and place in slots on left front and right rear of tank also marked with
the letter A. Secure with screws provided.
3. Take caster feet marked with the letter B and place in slots on right front and
left rear of tank also marked with the letter B. Secure with screws provided.
4. If flat washers are included in hardware package place flat washer over stem of caster before installing
casters into feet. NOTE: Flat washers are not required with all units.
5. Insert casters into feet by placing stem of caster into holes provided. Apply
pressure and twisting motion until casters snap into place. Return tank to
upright position.
PLASTIC TANK WITH REAR CASTER BASKET
You will find four casters, two caster feet, one basket and four screws with your wet/dry vacuum.
If your caster basket looks like the one shown to the right, assemble as follows.
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down so that the
bottom is facing up.
2. Insert two caster feet into adjacent slots at front of tank. Secure with screws provided.
3. Take basket and place into remaining slots at back of tank. Secure with screws
provided.
ASSEMBLY
Screw
Caster
Foot
Screw
Caster
Foot
Caster
Caster
Foot
PAGE 5

Publicidad

loading

Este manual también es adecuado para:

Qpl serie92 serie14rt serie