Upright SL26 Serie Manual Del Usuario página 12

O
PERATION
Before operating the work platform, ensure that the Pre-Operation Safety Inspection has been completed
and that any deficiencies have been corrected. Never operate a damaged or malfunctioning machine.
The operator must be thoroughly trained on this machine.
S
T A R T I N G T H E
1. Mount the platform and properly close the entrance.
2. Depress and hold the GLOW PLUG button for approximately 5 seconds.
3. Press green START button.
T
R AVE L
1. Check that the route is clear of obstacles (persons, obstructions, holes, drop-offs, bumps, and debris),
is level, and is capable of supporting the wheel loads.
2. Verify that the Engine is started and the Chassis Emergency Stop Switch is ON (pulled out).
3. Mount the platform and properly close the entrance.
4. Check clearances above, below, and to the sides of platform.
5. Twist the Platform Emergency Stop Switch out to the ON position.
6. Select DRIVE mode.
NOTE: Choose between standard drive and extra torque depending on the gradient.
7. Engage the Safety Interlock Trigger and move the Joystick to FORWARD or REVERSE to travel in the
desired direction. The speed of the machine will vary depending on how far from center the Joystick is
moved.
S
T E E R I N G
1. Turn the Drive/Lift Switch to DRIVE.
2. While engaging the Safety Interlock Trigger, push the Steering Switch to RIGHT or LEFT to turn the
wheels in the desired direction. Observe the tires while maneuvering the work platform to ensure proper
direction.
NOTE: Steering is not self-centering. Wheels must be returned to the straight ahead position by
operating the Steering Switch.
E
L EVA T I N G T H E
1. Select a firm, level surface.
2. Select LIFT mode.
3. While engaging the Safety Interlock Trigger, push the Joystick forward.
4. If the machine is not level the tilt alarm will sound and the machine will not lift or drive.
5. If the tilt alarm sounds the platform must first be fully lowered, then elevate the platform approximately
600mm (2ft), stop, press and hold the LEVEL button until the tilt alarm is silenced. Only then can you
elevate fully. If the platform is not levelled correctly the tilt alarm will continue to sound and lift functions
will be cut at a height of approximately 2m (6ft).
Page 8
E
N G I N E
W P
I T H T H E
P
L A T FO R M
L
L A T FO R M
Operation
OW E R E D
Operation Manual