cecotec BOLERO WASH&DRY 8580 INVERTER B Manual De Instrucciones página 127

The machine is continuously
filled with water and
continuously emptied.
The drained water returns to
the apparatus
Control panel gets hot
After drying, there are drops
of water on the door and
drum
The drying effect is poor and
uneven.
General issues
- Do not repair or replace any part of the appliance unless specifically instructed to do
so in this instruction manual. It may lead to a dangerous incident that endangers your
health and/or damages property.
- In case of fault or malfunction, contact the official Technical Support Service of Cecotec.
- Use original spare parts.
- IMPORTANT: do not come into contact with the following internal components while the
appliance is connected: inlet valve(s), drain pump, motor controller heat sink, PCB.
02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 127 02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 127
The top of the drain hose is too low. It should be installed at a
height of 65-100 cm from the ground.
The end of the drain hose has been pushed too far down into
the standpipe; the hose elbow must be installed 100 mm from
the end of the drain hose.
The end of the drain hose is submerged in the discharged
water.
If the end of the drain hose touches the discharged water
(water drained from the washing machine), it (the discharged
water) may be sucked back into the appliance and damage the
appliance or garments.
This is a slight heating effect of the electronic components on
the PCB board installed on the back of the control panel.
During drying, the door may be stained with water droplets,
wipe off the water droplets.
Do you wear too much or too thick clothing?
Do clothes that are not easy to dry (such as thick cotton
fabrics) and fabrics that are easy to dry (such as synthetic
fabrics) dry together?
Do you put too much laundry to dry?
When only running the "Drying" programme, do you separate
the tangled laundry to place it in the drum?
Due to different types and quantities of laundry, uneven drying
may occur. l Is the tap closed during drying?
Is the drain pump filter blocked during drying?
Is the drain hose bent, kinked, or blocked during drying?
Your appliance contains sensors that monitor progress during
the wash cycle (e.g. water level, temperature, unbalanced
loads, wash time/progress). Normally, if your appliance
completes the cycle successfully, it is unlikely that there will
be a problem.
BOLERO WASH&DRY 8580 INVERTER B/STEEL B
ENGLISH
127
29/6/23 16:38 29/6/23 16:38