Publicidad
Idiomas disponibles
Idiomas disponibles
The carrier units can be cleaned using water.
Locks
The locks must be maintained after several locking cycles have passed, and always after wet cleaning has
been performed. This process involves spraying the dust/dirt guard and the inside of the cylinder with an ap-
propriate lubricant and then actuating the lock several times using the key.
WARNING
Do not use any lubricants on the bolted connections.
Failure to comply with these instructions may result in the carrier units becoming detached,
causing injury to you or others and/or damage to property.
Caution
Do not use a high-pressure cleaner to clean the kayak holders.
3.5
Technical notes
Technical data
Dead weight of carrier unit set: approx. 5 kg (11 lbs.).
Roof load/load
To determine the roof load:
Weight of the carrier unit
+
weight of the roof rack module
+
weight of the load
=
roof load
WARNING
Never exceed:
◆ the maximum permissible roof load (100 kg/220 lbs.)
◆ the gross axle weight rating
◆ the gross vehicle weight rating for your vehicle
3.6
Adjusting the carrier unit width
Instructions for the qualified workshop if the position of the
support bracket for the relevant vehicle is not set correctly.
– Install the carrier unit on the vehicle ⇒ P age 7 and only tight-
en gently on the left-hand side.
Installation instructions - Audi A6 (4G) Avant 2012 ►
⇒ Vehicle Owner's Manual.
3 Installing/removing the carrier units
Edition 01
11
Publicidad
