Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Remote control
1. Connect the power cord after ensuring that voltage
supplied to your home corresponds to the values on
the appliance technical plate.
2. In order to provide power supply to the electric
convector, turn the power button to position I – the
display will flash for a while.
3. You can use the touch panel or the remote control
to adjust the electric convector
4. Push button
electric convector will operate at its maximum
power (2000W) and the display will show the value
of the room temperature
5. Using the buttons
whether the electric convector to operate at half
of its power (1000W) or at its full power (2000W).
That is indicated by lights at the right corner of the
display
•
One light on – half power 1000W.
•
Two lights on – full power 2000W
6. Setting the timer
•
Push button
0:00
•
Using the buttons
number of hours from 0 to 18 (the available options
are at 30-minute intervals) in order to adjust when
the electric convector to stop its operation
•
When adjusting the timer in Heating mode – the
appliance will turn off after the selected time period.
In Stand-by mode:
4
Usage and Storage Instructions
LED Display
Temperature increase/
decrease and time
adjustment button
Temperature
adjustment button
Timer button switching
on/off
ON/OFF button
, to turn on the appliance. The
and
, you can select
- the display will show indication
and
, one can set the
•
Step 1: you must to set the time, from 0 to 18 hours.
For example 2 hours.
•
Step 2: you must to set the temperature. For
example 20 °C.
•
Step 3: you must to set the power. (The default
power: 2000W)
•
After 2 hours, if the room temperature is lower than
20 °C, heater will start to work..
Noted: you must set the timer firstly, and then you
can set the temperature
7. Setting the thermostat
•
In order to set the room temperature you desire –
push button
•
Using the buttons
desired temperature in the range from 5 to 36
degrees Celsius
•
Digital display will start blinking showing the user
selected temperature.
•
After 5 seconds the display will stop blinking and
will show the room temperature.
Note: The device shows the temperature around the
location of the sensor and is not a means of accurately
measuring the ambient temperature.
MOVING THE APPLIANCE:
If it is necessary to move the appliance to another place
of operation, switch it off by pulling the power plug
out of the socket, holding the appliance handles with
both hands, move it to its new position, having in mind
that the appliance must get cold (cooled down) before
doing this. Moving hot appliances may lead to bad
consequences for the user like burns or inflammable
materials entering the electric convector during its
movement.
IN-BUILT OVERTURN (FALL) PROTECTION SWITCH
The electric convector has got an in-built overturn
protection switch. In case the electric convector
overturns, the power supply will be stopped. Let the
electric convector cool down and then put it into
upright position again. The appliance will restore its
normal operation.
AUTOMATIC SAFETY STOP
There is an in-built device in the electric convector (self-
restoring thermal switch), which actuates automatically
and switches off the electric convector in case of
overheating. The thermal switch will restore its normal
state when the appliance temperature decreases to its
normal level.
and
you can adjust the
Publicidad
