Graham Field LUMEX 7108A Manual De Instrucciones página 2

SETUP (REFER TO PICTURE BELOW)
s NOTICE: DO NOT use excessive force when installing the seat and lid.
1. Remove frame, seat, lid, pail, cover, and splash guard from carton.
2. Attach front support bar to armrest by depressing the locking button and sliding into the front
support bar channel guide until it clicks into place. Repeat for other side. Ensure the locking
buttons protrude fully from the holes.
3. Attach seat to rear support bar. Push down firmly until the seat snaps into place.
WARNING: When installing the seat on the frame, ensure the seat is evenly spaced
between the side frames to ensure proper stability.
4. Attach lid to rear support bar.
5. In the upright position, place splash shield or pail and cover in frame.
Adjusting Commode Height
1. Depress the height adjustment button and slide the lower leg upward or downward until the
height adjustment button clicks into place in the desired hole.
2. Repeat for other 3 legs.
WARNING: Ensure that all four commode legs are adjusted to the same height, and
that all height adjustment buttons protrude fully through adjustment holes
before use.
LX_7108-INS-LAB-RevC23
Lid
Seat
Armrest
Frame
Height Adjustment
Holes
Height Adjustment
Button
Lower Leg
Tip
7108R Folding Steel Commode
Pail
Pail Support
www.grahamfield.com
Back Support
Back Support
Channel Guide
Rear
Support Bar
Front
Support Bar
Front Support Bar
Channel Guide
2