Publicidad
Idiomas disponibles
Idiomas disponibles
·
For the best results, clean the dust reservoir and the filters after each use. This is better for the suction
power and the life span of the machine. Make sure that the dust in the dust reservoir does not exceed
the maximum level.
ACCESSORIES
You can use the following accessories on the hand-held vacuum cleaner (by removing the shaft) or secure
them on the shaft:
1.
Dust brush: for
furniture, bookshelves, curtains and hard to clean surfaces.
2.
Crevice
vacuum
cleaner: for crevices, corners, stairs, keyboards,...
1
CLEANING AND MAINTENANCE
CLEANING THE MACHINE
Clean the machine with a slightly moist soft cloth. Dry the machine off well. Never submerge the machine
in water!
CLEANING THE DUST RESERVOIR
1.
Never exceed the maximum indicator on the dust container. Empty the
dust container by pressing the release button. The dust container falls
open and you can then remove the coarse dirt.
2.
Remove the wand. Then take the handle in your right hand. Grasp the dirt
receptacle with your left hand and turn it clockwise. The dirt receptacle
will come loose from the motor section. You can now clean all the parts
separately. We recommend you do this with compressed air. If you do
not have compressed air, you can wash out the filters. Make sure they are
completely dry before using them again.
- Black round filter: this is located at the exit of the motor and filters the
air even more after it comes out of the appliance.
- HEPA filter: this round dust filter captures the small dust particles.
- Plastic coarse debris filter: this ensures that the large dust particles
remain in the dirt receptacle.
- Dirt receptacle: this is where all large dirt particles are collected.
3.
Pull the filters out of the dirt receptacle. Remove the HEPA filter from the
coarse debris filter by pulling it up. Blow the filters clean with compressed
air. You can also clean the filters under running water. Make sure they are
completely dry before using the appliance again.
4.
Replace the HEPA filter in the coarse debris filter.
5.
Put the filters back in the dirt receptacle. Make sure that the notch in the filter
lines up with the protrusion in the receptacle.
6.
Put the dirt receptacle back on the motor section by turning it counter-clockwise.
Make sure that the dash on the motor unit lines up with the lock symbol.
www.domo-elektro.be
2
1
1
31
DO1104SV
Publicidad
