Publicidad
Idiomas disponibles
Idiomas disponibles
How to Assemble Your Ceiling Fan Blades
1.
Lay flat side of blade holder on a flat surface with
the inside of the blade holder arm facing up. This is
the side with the threaded posts and pitched foot.
Position the blade over the blade holder with the
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade holder.
Place blade cover on top of the blade, positioning the
holes over the threaded posts. With a phillips
screwdriver, thread three screws into the posts but do
not fully tighten. Prior to final tightening, position the
centerline of the blade holder with the center of the
end of the blade. Tighten three screws to secure the
blade. (Figure 1)
NOTE: You will find the fan blade set packed in its
own carton and the blade holders, blade cover and
hardware bag in the fan box.
2.
Secure the blade holders to the flywheel using the
1/4˝-20 screws, the post on the blade holder need to
align the hole between the 1/4"-20 threaded holes
located on the bottom of the flywheel. (Figure 2)
NOTE: Periodically check blade holder hardware and
resecure if necessary.
WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in
between the rotating blades.
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
Blade Cover
Blade
3/16"-24
Pan Head
Serrated Screws
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
1/4˝-20
Pan Head
Screws
14
3/16˝-24 Pan Head Serrated Screw
(3 each per blade)
Figure 1
HARDWARE USED:
1/4˝
Pan Head Screw
(2 per assembly)
Figure 2
HARDWARE USED:
x 18
Blade Holder
x 27
Blade Holder
-20
Publicidad
