Publicidad
Idiomas disponibles
Idiomas disponibles
P
REPARATION
Cables not included.
Please purchase the necessary cables at your local store.
Basic Connection
This section describes how to connect the unit to an antenna, cable receiver or satellite box.
Note:
• Be sure your antenna or other device is connected properly before plugging in the AC power cord.
[Antenna Connection]
Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.
e.g.)
VHF / UHF
antenna
cable TV signal
*
Once connections are completed, turn on the unit and begin initial setup.
Channel scanning is necessary for the unit to memorize all available channels in your area.
(Refer to "Initial Setup" on page 12.)
Note:
• If you have any question about the DTV's antenna, visit www.antennaweb.org for further information.
• For your safety and to avoid damage to this unit, please unplug the RF coaxial cable from the antenna input jack before moving the unit.
• If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than
settop versions.
• To switch your reception source easily between antenna and cable, install an antenna selector.
• If you connect to the cable system directly, contact the CATV installer.
[Connection to Cable Receiver or Satellite Box]
Use an HDMI or an RCA component video cable to connect the HDMI or the component video input jack of the unit to the
HDMI or the component video output jack of the cable receiver / satellite box.
If you connect to the unit's COMPONENT1 or COMPONENT2 video input jack, connect an RCA audio cable to the audio
L/R jack of COMPONENT1 or COMPONENT2 accordingly.
e.g.)
satellite dish
or
cable TV signal
including PPV
*
You can also connect this unit to the cable receiver or satellite box other than the HDMI or the component video
output jack because they might have different output jacks.
*
Required cables and connecting methods of the cable receiver / satellite box, or the availability channel for the clear
QAM may differ depending on the cable/satellite provider. For more information, please contact your cable/satellite
provider.
8
EN
or
HDMI OUT
AUDIO OUT
L
ANT IN
RF coaxial
cable
STEREO
PCM
cable receiver / satellite box
RF coaxial cable
HDMI cable
or
COMPONENT VIDEO OUT
R
Y
Pb/Cb
Pr/Cr
RCA component video cable
and RCA audio cable
(green)
(green)
(blue)
(blue)
(red)
(red)
(green)
(green)
(blue)
(blue)
(red)
(red)
rear of this unit
or
DIGITAL
VIDEO 1
VIDEO 2
COMPONENT 1 COMPONENT 2
AUDIO OUT
(COAXIAL)
Y
Y
S-VIDEO
S-VIDEO
Pb
Pb
VIDEO
VIDEO
Pr
Pr
HDMI-IN
L
L
L
L
L
AUDIO
AUDIO
AUDIO
AUDIO
AUDIO
R
R
R
R
R
rear of this unit
Publicidad
