Publicidad
Idiomas disponibles
Idiomas disponibles
Spark Plug Gap
(See recommendations)
(Fig. 3)
Operator's Manual
MAINTENANCE
CLEANING AND GAPPING SPARK PLUG (GASOLINE ENGINES ONLY):
If the plug is contaminated with carbon, remove it using a plug cleaner or
wire brush.
Check the spark plug gap and reset it if necessary. The spark plug gaps are
listed below. To change the gap, bend the side-electrode only, using a spark
plug tool. (Fig. 3)
Install and tighten the spark plug. Connect the spark plug lead.
Recommended Spark Plug:
ENGINE
Spark Plug
NGK BPR6ES
Spark Plug Gap
0.7 - 0.8 mm (0.03 in.)
Torque - New
8.7-10.9 ft-lb
Torque - Retighten
16.6-19.5 ft-lb
BELT TENSION ADJUSTMENT:
To maintain peak performance of your unit, it may be necessary to adjust the
belt tension on occasion. Follow the procedure outlined below:
1. Remove the beltguard and loosen the two nuts on each side of the pump
or engine. There are a total of 4 nuts.
2. Turn the cap screw clockwise until a 1/2 inch belt deflection is noticed
between the pulleys.
3. Tighten the side nuts.
4. Put a straight edge across both pulleys. If necessary, loosen one set of
pulley screws and adjust in or out to properly align. Tighten the pulley
screws and check the tension again.
5. Replace the beltguard and tighten the fasteners securely.
26
HONDA
Publicidad
