Descargar Imprimir esta página

DeLonghi EX CST Serie Manual De Instrucciones página 11

Ocultar thumbs Ver también para EX CST Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

appears in the Standby mode.
NOTE: pairing must be done within 60 seconds.
FCC AND CANADA EMC COMPLIANCE INFORMATION
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Please note: This equipment has been tested and found to com-
ply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential instal-
lation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and ON,
the user is encouraged to try to correct the interference by one
or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and re-
ceiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
Approved under the certification provision of FCC Part 15 as a
Class B Digital Device.
Caution: Changes or modifications not expressly approved by
the manufacturer could void the user's authority to operate this
device.
Caution: To comply with the limits of the Class B digital device,
pursuant to Part 15 of the FCC Rules, this device is to comply with
Class B limits. All peripherals must be shielded and grounded.
Operation with non-certified peripherals or non shielded cables
my result in interference to radio or reception.
This Class B digital apparatus complies with Canadian ICES-003.
CAN ICES-3 (B)/NMB-3(B)
WIRELESS TRANSMITTER COMPLIANCE INFORMA-
TION
The term "IC:" before the radio certification number only signi-
fies that Industry Canada technical specifications were met.
This device complies with Industry Canada's licence-exempt
RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interfer-
ence that may cause undesired operation of the device.
This equipment complies with FCC and IC radiation exposure
limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm
between the appliance and your body. This transmitter must
not be co-located or operating in conjunction with any other
antenna or transmitter.
FCC/IC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC/IC RSS-102 radiation
expo-sure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Host device Labeling
This device includes the following module.
Contains FCC ID: WAP-2011
Host device Labeling
This device includes the following module.
Contains IC: 7922A-2011
FCC Responsible party:
De Longhi America
Upper Saddle River NJ 07452
201-919-4000
USAGE TIPS
The CST remote control has humidity/temperature sensors
on board. It is suggested not to completely cover it with
hands or clothes; it is as well suggested not to place in ob-
structed air flow zones. In addition to that it is preferable to
keep the device far from direct sunlight exposure or heat
sources in order to avoid inaccurate sensor readings.
The CST remote control is equipped with touch sensitive
buttons. Operate with clean hands and without dust or
liquids nearby.
The CST Remote control is expected to run for approx. 6
months with the same batteries. This assumption is based
on the use of 2300 mAh LR6 "AA" batteries.
11

Publicidad

loading

Este manual también es adecuado para:

Ex cst ex360lvynEx cst ex360lvyn-6a