Publicidad
Idiomas disponibles
Idiomas disponibles
Tips before Installation /
Your Room Air Conditioner unit is designed to
be highly efficient and save energy. Follow these
recommendations for greater efficiency.
1. Select thermostat setting that suits your
comfort needs and leave the thermostat at
that chosen setting.
2. The filter is very efficient in removing airborne
particles. Keep air filter clean. Normally, filter
should be cleaned once a month. More
frequent cleaning may be necessary depending
on outdoor and indoor air quality.
3. Use drapes, curtains, or shades to keep direct
sunlight from heating your room, but DO NOT
obstruct the air conditioner. Allow three(3) inches
around unit to circulate.
4. Start your air conditioner before outdoor
air becomes hot and uncomfortable. This
avoids an initial period of discomfort while
the unit is cooling off the room.
5. When outdoor temperature is cool
enough, use HI or LOW FAN ONLY
This circulates indoor air, providing
some cooling comfort, and utilizes less
electricity than when operating on a
cooling setting.
Your Room Air Conditioner was designed
for easy installation in a single or double-hung
window. NOTE: This unit is NOT designed for
vertical (slider type) windows.
A
CAUTION
A
To avoid installation/operating difficulties,
read the instructions thoroughly.
NOTE:
Save the shipping carton and packing
materials for future storage or transport of the unit.
Please check the contents of hardware kit against
the corresponding model check list, prior to
installation of the unit.
See lists below.
Installation Hardware
3/4"Screws (7)
Seal(1)
2/5"Screws (11)
Foam(1)
Top Channel(l)
Channel Seal(1)
Side Curtain RH(1)
Side Curtain LH(1)
L Bracket(2)
NOTE: Surplus screw(s) for spare use.
Tools Needed for Window Installation
Screw drivers: Both Philips and flat head
Power drill:
1/8 inch diameter drill bit
Pencil
Measuring tape
Scissors
Cutter
Carpenters level
Publicidad
