Publicidad
Idiomas disponibles
Idiomas disponibles
EN
USING YOUR TOWER FAN (CONT.)
4. Tap
Mode off.
Sound and Display Off
1.
Press and hold
off selection sounds and the display.
2. Optionally, press
control.
3. After 5 seconds of no operation, the
display will automatically turn off and
selection sounds will be disabled.
4. Tap any button to temporarily turn the
display back on. If you don't tap another
button, the display will turn back off after
5 seconds.
5. Press and hold
press
on the remote) to turn on
selection sounds and the display.
Standby Mode
•
The tower fan is in Standby Mode
when it is turned off, but plugged in.
•
Tap
Memory Function
When the tower fan is in standby or turned
off and unplugged, it will remember all its
previous settings, except for timer.
8
or
to turn Advanced Sleep
for 3 seconds to turn
on the remote
for 3 seconds (or
to turn the tower fan on.
CARE & MAINTENANCE
Cleaning the Tower Fan
1.
Unplug before cleaning.
2. Wipe the outside of the tower fan with
a soft, dry cloth. If necessary, wipe
the housing with a damp cloth, then
immediately dry.
3. Use a vacuum, duster, or compressed air
to clean the inside of the tower fan.
4. If necessary, use a screwdriver to remove
the back cover and clean the inside of
the tower fan. [Figure 4.1]
Notes:
• Make sure the tower fan is turned off
before removing the back cover.
• Clean the internal parts with a dry
cloth.
• Do not clean with abrasive chemi-
cals or flammable cleaning agents.
• Do not allow water to drip into the
motor housing.
Replacing the Remote Control
Battery
1.
Insert a coin/button battery into the slot
and rotate counterclockwise to remove
the battery compartment. [Figure 4.2]
2. Remove the old battery.
3. Replace with a new 3V CR2025 battery.
Make sure the polarities match.
4. Replace the battery compartment.
Storage
If not using the tower fan for an extended
period of time, cover the tower fan and
store in a cool, dry place to avoid moisture
damage.
Publicidad
