USING THE SHORTCUT WARM/CANCEL FUNCTION
1. Press and hold "Warm/Cancel" button to start the process. Keep warm time will display
when the indicator light is on. The cooker shuts down automatically in 12 hours.
2. To end the process, press and hold "Warm/Cancel" button.
Note: The automatic keep warm function starts when any one of the functions ends.
USING THE REHEAT FUNCTION
1. Press and hold "Start/Reheat" button to start, and the green light will turn on.
2. Press "Time/Temp" button.
3. Use "-" and "+" buttons to select your desired reheating time.
4. Once complete, the appliance will automatically switch to the keep warm mode.
5. Press and hold "Warm/Cancel" button to end the process.
Note: Both keep warm and reheat functions can only initiate when the cooker is in
'standby' mode.
MIDWAY ADDITION + SAFETY LOCK FUNCTIONS
USING THE 'MIDWAY ADDITION' FUNCTION
1. To use the function, press the "Steam Release" button on the digital control panel for
3 seconds and the appliance will release steam automatically (which will take a few
minutes). Once the
2. steam is completely released, the appliance will buzz and the "Release Pressure"
indicator light will go off.
3. Safely open the cover and add food into the pot.
4. After the food is added, close the cover, and the cooker will resume the previous
operation until the cooking is done.
5. Once complete, the appliance will automatically shift to the keep warm mode.
6. Press and hold "Warm/Cancel" button to end the process.
USING SAFETY LOCK FUNCTION
1. After the cooking process has started, press and hold the "Preset/Safety Lock" button
for 3 seconds.
2. The indicator light of "Safety Lock" will turn on.
3. To cancel it, press and hold the "Preset/Safety Lock" button for 3 seconds.
CLEANING AND MAINTENANCE
1. Unplug the cooker from the power supply and clean after each use.
2. Using a soft, damp cloth, wipe the outer surface of the machine. You can use a mild
detergent to remove dried food if required.
3. Clean the inside of the cooker including seal ring, cover plate, exhaust valve inlet and
outlet, pressure float, air-out vent, float valve, water collection container (located at the
back of the appliance). Then wipe dry.
- 9 -
English