Arcam AV41 Manual página 21

Front Panel Operation
VOLUME
Adjusts the analogue output volume
in the selected zone (line out,
speakers and headphones).
PHONES
This socket accepts headphones
with an impedance rating
between 32Ω and 600Ω, fitted
with a 3.5mm stereo jack plug.
AUX
Auxiliary line level input.
INPUT
These buttons select the source
connected to the corresponding
AVR31
input (or internal input)
Unused sources can be prevented
from being selected in the setup
menu by blanking the name in
MENU > Input Config.
Selects between Stereo and
the available surround modes
for the current source.
OK
Used to enter selections
made in the Setup menu.
PHONES AUX
MENU IN - / 6
MENU
Selects the Setup menus.
MODE
IN + / 5 OK INFO / 3 MODE / 4 MUTE DIRECT DISPLAY
MUTE
Mutes all analogue audio outputs in the
currently selected zone.
INFO
Selects the information
displayed on the lower left
portion of the front panel.
EN-19
DIRECT
Stereo Direct on/off. Provides a direct analogue path from
the analogue inputs to the left and right front outputs.
Switches off any surround processing modes and shuts
down the DSP circuits for best stereo sound quality.
DISPLAY
This switches the display brightness
between off/dim/bright.
ZONE (AVR21, 31, 41)
Selects between Zone 1 and
Zone 2 control.
SYNC (AVR11)
Adjusts lip-sync
POWER/STANDBY LED
This indicates the status of the receiver and is
green when the Receiver is powered on. Red
indicates the unit is in Standby mode.
HOME THEATRE
Switches the main power to the
POWER
seconds before switching on again.
ZONE
Remote Control Receiver. This is positioned behind the
display window, on the front panel. Ensure the receiver
is in a clear line of sight from the remote control for
operation. If this is not possible, use a separate sensor
connected to the
EN
POWER
Receiver on and off.
Once the unit is switched off,
it should be left for at least ten
input on the rear panel.
Z1 IR