YATO YT-07140 Manual página 11

PRODUCT OVERVIEW
The oil extraction pump makes it easy to change engine oil. The oil can be changed via the oil level dipstick
opening. The pump is powered by a battery with a nominal voltage of 12 V. Correct, reliable and safe operation
of the device depends on correct operation, therefore:
Read the entire instructions manual before the fi rst use of the product and keep it for future reference.
The supplier shall not be held liable for any damage resulting from failure to observe the safety regulations and
recommendations specifi ed in this instructions manual. Use of the product for purposes other than those for
which it was intended shall cause the loss of the user's rights to the guarantee and under warranty.
PRODUCT ACCESSORIES
The product is delivered complete but requires assembly for operation. Battery is not included with the product.
The following are supplied with the product: a rigid inlet hose for engine oil extraction, a fl exible inlet hose for
diesel extraction, a fl exible drain hose with a larger diameter, a drain hose clamp, quick disconnect couplings
for attaching the hoses to the inlet.
TECHNICAL DATA
Parameter
Cat. No.
Rated voltage
Rated power
Max. pump capacity
Recommended oil temperature
Protection rating
Insulation class
Weight
SAFETY INSTRUCTIONS
Caution! Read all the following instructions. Failure to do so may result in electric shock, fi re, or personal injury.
OBSERVE THE INSTRUCTIONS BELOW
Do not use the product in an explosive environment with fl ammable liquids, gases or vapours.
Before starting the product for the fi rst time, make sure that the product, its accessories, and the power cord
have not been damaged. If any damage is discovered, it is forbidden to start working with the product. Any
damaged components, including the power cord, must be replaced at an authorised facility. It is forbidden to
repair the product on your own.
Use personal protective equipment such as protective goggles, gloves and earmuff s during operation. Work
clothes with long sleeves and legs and protective footwear with an anti-slip sole.
The product is intended for indoor use only. Do not expose the product to any precipitation or moisture. If
water and moisture enter the product, the risk of an electric shock is signifi cantly increased. Do not immerse
the product in water or any other liquid.
This product may only be powered by a battery with a rated voltage of 12 V. It is recommended to use charged
EN
Unit
[VDC]
[W]
[l/min]
[°C]
[kg]
M A N U A L O R I G I N A L
Value
YT-07140
12
100
2-4
40 – 50
IPX0
III
1.2
11