Publicidad
Idiomas disponibles
Idiomas disponibles
• Loosen the screws on the corner of the worktop diagonally
to the corner with the switch and screw them to the top of
the dust extraction hose bracket (g) - shown in the above
picture with the top standing on its legs.
• Place the worktop back on its feet on a flat, stable and level
surface.
• After making sure that the table is level and its legs are
evenly spaced from each other, you can tighten all the
screws securing them.
• Attach the transport handles to the legs on one side of the
table using screws, 2 washers and nuts.
• Press the rubber foot on the bottom of each leg.
EN
Publicidad
