Publicidad
Idiomas disponibles
Idiomas disponibles
USING THE CARPET CLEANER WITH HOSE & TOOL
9. Empty the dirty water tank
when the dirty liquid reaches
the "Max Fill" line and there is a
loss in suction. See instructions
in the EMPTYING DIRTY
WATER TANK (page 16-17).
10. When finished cleaning
with the hose and tool, it is
EMPTYING THE DIRTY WATER TANK
WARNING
Always unplug power cord
from electrical outlet before
performing any service on
carpet cleaner.
Empty the dirty water tank
when the dirty liquid reaches the
"Max Fill" line and there is a loss
in suction. During normal use,
debris may accumulate in the
dirty water tank. In order to keep
the carpet cleaner functioning
properly, rinse out the dirty water
tank with clean water after each
use.
suggested to rinse the inside
of the hose and tool by turning
the carpet cleaner on to suck
up warm clean water.
11. Once you have completed
cleaning, push the power
button again to turn the carpet
cleaner off; unplug the power
cord plug from the outlet.
12. Detach the hose and the
tool. Be sure the end of the
cleaning solution delivery tube
is removed from the cleaning
solution outlet. Press both the
hose release clips to remove
the hose from the nozzle.
13. Close the flexible hose door.
1. Open both the dirty water tank
locking latches. Hold the dirty
water tank holder to lift up the
dirty water tank from the main
body as shown.
- 16 -
Publicidad
