Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING THE BRUSHROLLS AND NOZZLE COVER
NOTE:
Make sure the nozzle
cover is properly installed.
WARNING
Always unplug power cord
from electrical outlet before
performing maintenance to the
carpet cleaner.
Replace the belt whenever a
burning rubber smell caused by
excessive slippage occurs.
1. Push the recline button; lay the
carpet cleaner on floor with the
bottom up and the floor nozzle
flat.
2. Use a Phillips head screwdriver
to remove the three screws
as indicated in the illustration
from the lower plate.
CHANGING THE BELTS
- 21 -
3. Remove the two small covers
which are secured by the screws.
4. The two brushrolls are connected
together as an assembly. Lift
the brushroll assembly up to
the angle as shown.
5. Carefully remove the belt end
cover on the left side of the
brushrolls as shown. You will
see one belt here.
Brushrolls
Publicidad
