Foppapedretti iNanna Manual De Instrucciones página 17

• ENGLISH •
STEP 1
Crib structure: Press the bottom of the crib downwards, as shown in the figure.
WARNING! - Only use the crib when it is attached to the frame.
STEP 2
Assembling the feet: Push the metal pin and insert the feet (D) into the left and right legs (B and C). A click
will indicate that it has locked correctly.
The components are correctly assembled when the metal pin is locked into the hole on the leg.
STEP 3
Assembling the frame: Align the upper reinforcement bar (E) with the upper bracket on the left leg (B) as
shown in fig. 3.
Push the metal pin on the upper reinforcement bar (E) as shown in fig. 3 and insert the upper reinforcement
bar on the left leg. The components are correctly assembled when the metal pin is locked into the hole on
the support bar. A "click" will indicate that it is locked in successfully.
Align the lower reinforcement bar (F) with the lower bracket on the left leg (B) as shown in fig. 3.
Push the metal pin on the lower reinforcement bar (F) as shown in fig. 3 and insert the lower reinforcement
bar on the left leg . The components are correctly assembled when the metal pin is locked into the hole on
the support bar. A "click" will indicate that it is locked in successfully.
Repeat the step to secure the upper and lower support onto the right leg (C).
STEP 4
Securing the crib to the frame: Align and insert the left and right support of the crib into the uppermost
part of the left and right leg (B and C) as shown in fig. 4.
Insert the screw (G) into the left and right support (fig. 5) and firmly tighten it to secure the crib to the
frame.
Before use, ensure the zip which fastens the fabric on the upper ring is completely closed.
Attach the crib with the Velcro straps (fig.6).
STEP 5
Mattress: Place the mattress inside the crib (fig. 7).
TO USE
ADJUSTING THE HEIGHT OF THE CRIB
The crib height can be adjusted to different positions. To adjust its height, press the adjustment lever (on
the left and right) and at the same time lift or lower the crib until you reach the desired position (fig. 8).
Release the lever. Make sure that it is correctly locked in the chosen position
The base of the crib can be tilted slightly (fig. 9).
WARNING: you can tilt the crib with a maximum of 2 positions' difference between one leg and the other
(for example, with the right leg in position 10 and the left in position 8).
WARNING: The child's head must always be placed on the most raised side.
POSITIONING IT NEXT TO THE BED
If there is enough space between the bed and the floor, place the structure next to the adult's bed and
slide the feet of the crib under the bed, see fig. 10.
If there is not enough space between the bed and floor, place the structure next to the adult bed, see
fig. 11.
Adjust the height of the crib so that it is next to or above the adult's bed.
17