Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING AND MAINTENANCE
DRAINING
Permanent drain
During the "dry" mode you can use a permanent drainage.
1. Remove the drain plug and the rubber top.
2. Attach the drain hose on the drain.
3. Make sure the water is drained in a safe and permanent way.
Drain code P1
When you don't use the permanent drain, the non recycled
condensation water, will be stored in the water tank.
When the water tank is full a few beep signals will be heard and on
the display the code P1 will appear. The "cool" or "dry" mode will end
automatically. The fan will continue to operate, this is normal.
1. Move the unit over to a place where you can easily drain the water.
2. Remove the drain plug at the bottom of your unit and drain the
water.
3. After fully draining the water tank, place the drain plug back on the
drain opening.
Restart the unit, make sure the error code P1 is no longer displayed.
When the code doesn't disappear, try turning off and on the unit a few times. When the error code
continues, please contact the after sales service.
ATTENTION : always make sure to install the drain plug, before turning the unit back on.
CLEANING
I
Always remove the plug from the socket before cleaning the unit.
I
Never use any chemical or abrasive products to clean the unit.
I
Never clean the unit with water or any other liquid, this can cause electrocution.
I
When the power cord is damaged it must be repaired or replaced by the after sales surface of
the manufacturer or by a qualified person.
www.domo-elektro.be
81
Publicidad
