SICE S 65 Manual De Instrucciones página 91

ALU 3 balancing programme:
calculates statistically the balancing weights to be applied on the inner part (inner and
outer side) of the rim, as illustrated by the icon.
ALU 4 balancing programme:
calculates statistically the balancing weights to be applied on the inner side and the
inner part, outer side of the rim, as illustrated by the icon.
ALU 5 balancing programme:
calculates statistically the balancing weights to be applied on the inner part and the outer
side of the rim, as illustrated by the icon.
- After performing a spin, when in the centred position, the video displays instructions
for where to position the balancing weights relating to the selected programme: always
to 12 o'clock if the weight is a conventional clip type, whereas for the application of the
adhesive weight, use 3 o'clock as a reference if the "H3" configuration is active, 6 o'clock
if the "H6" configuration is active or 12 o'clock if the "H12" configuration is active.
- Set the wheel's rated geometric data by following the steps described in the WHEEL
DATA ENTRY chapter. If the values of the diameter and of the distance between the
balancing planes, recalculated on a statistical basis starting from the rated geometric
data of the wheel, exceed the normally accepted interval stated in the TECHNICAL
DATA section, the A5 message is displayed.
IMPORTANT: in ALU1 and ALU2
programmes the unbalance dis-
played by the machine
on the outer side refers to the ad-
hesive weight centre of gravity at
the shaft assembly
bearing flange, see figure 17a.
Some minor residual unbalance
may remain at the end of the spin
test due to the considerable dif-
ference in shape found in rims
with the same nominal diameters.
Therefore change the value and
User manual S 65
UK
17a
91