SICE S 65 Manual De Instrucciones página 97

18. press Enter
19. perform a spin. When the spin is over the optimisation programme has been completed
and the weights to be applied to balance the wheel are displayed.
The machine displays the message E 6 in the event of an error influencing the final result.
The procedure can now be repeated.
The error message disappears by selecting any of the available functions.
Special Cases
- At the end of the first spin, the message "OUT 2" may be displayed on the screen.
In this case, it is convenient to exit the programme by selecting exit
values needed to balance the wheel will be shown on the monitor. The programme
execution is interrupted, thus not achieving the moderate improvement of the end
results. However, the optimisation procedure can be run by selecting the OPT continue
procedure icon.
- At the end of the second spin, the indication to invert the tyre mounting on the rim
may be displayed. If you do not want to invert it or it is impossible to do so, select the
disable tyre inversion icon. The machine will provide the instructions to complete the
programme without inversion.
The Enable tyre inversion icon restores the inversion function.
- It is possible to exit the optimisation procedure at any time by simply selecting the
Exit key twice
- If a different working environment is recalled between one step of the OPT programme
and the next one, the OPT procedure always remains stored. Therefore, going back to the
start environment, the programme resumes the execution from the point where it was
interrupted. This situation is possible when the Temporary Exit icon is selected.
Weight management suite (WEIGHT REDUCTION)
WEIGHT REDUCTION is a suite of 4 programmes:
1. Hidden Weight
2. Split Weight
3. OPT flash
4. Weight reduction.
Note: the Hidden Weight, Split Weight and OPT Flash programmes are available even if
WEIGHT REDUCTION is not active.
To access this suite you must:
User manual S 65
again to confirm the operation;
.
: the weight
UK
97