Publicidad
Idiomas disponibles
Idiomas disponibles
ƒ Microprocessor controlled charging (CC-CV for Li-Ion, 0dV/-dV for
NiMH)
ƒ Automatic battery full detection and completion of charging process
ƒ Trickle charge function for NiMH batteries
ƒ Indication of the charging status via 3 LEDs per charging slot
ƒ Indicates batteries inserted with wrong polarity
ƒ Operates via 5V DC USB adapter (not supplied)
ƒ 3 years warranty
OPERATION
To operate the charger, connect the USB-C connector of the charging
cable to the charger and the USB-A connector to any USB power adap-
ter with minimum 1A output current (e.g. your USB charger that you use
for charging your smartphone). After connecting, the device performs a
quick function test, each LED lights briefly.
With this charger you can charge 1-2 Li-Ion, 1-2 NiMH battery or each 1
Li-Ion and 1 NiMH battery at the same time and independently.
For charging the battery, pull back the silver negative (-) contact and
insert the battery in the correct polarity (according to the plus and mi-
nus symbol shown in the charging slot). The microprocessor-controlled
charger detects automatically the inserted battery and its voltage and
chooses the right charging mode. Charging starts automatically and
the charging status of each battery is indicated via 3 LEDs per slot
(see LED DISPLAY).
It is normal for the batteries to become warm when charging. After the
battery is fully charged all 3 LEDs light up permanently. NiMH batteries
are held in a state of trickle charge after they are full.
LED DISPLAY
1 LED flashes:
arging is in process, charging status < 30%
1 LED lights permanently /
1 LED flashes:
charging is in process, charging status >
30% / < 60%
2 LEDs lights permanently /
1 LED flashes:
charging is in process, charging status >
60% / < 100%
3 LEDs lights permanently: charging process completed / battery is
fully charged
3 LEDs flashes:
reverse polarity of battery, please insert
correctly
ENVIRONMENT
Do not dispose of this charger in the normal household waste. Please
return it to your dealer, nearest recycling centre or collection point.
Please also recycle all packing materials.
CARE & MAINTENANCE
To make sure that the charger works properly, please keep the con-
tacts free from dirt and dust. To clean the unit disconnect it from the
mains and only use a dry clean cloth.
Deutsch |
Español | Nederlands | Svenska | Suomi
English
| Français
TECHNICAL DATA
Input:
5V DC / min. 1000mA
Output:
1x 3.6/3.7V / 1000mA (Li-Ion)
2x 3.6/3.7V / 500mA (Li-Ion)
1-2x 1.45V / 500mA (NiMH AA/AAA)
Input:
5V DC / min. 2000mA
Output:
1-2x 3.6/3.7V / 1000mA (Li-Ion)
1-2x 1.45V / 500mA (NiMH AA/AAA)
DISCLAIMER
Information in these operating instructions can be changed without
prior notice. ANSMANN cannot accept liability for direct, indirect,
accidental or other claims by not using this charger as indicated by
these operating instructions. Consequential losses are not accepted
at any time.
WARRANTY NOTICE
We hereby offer a 3 year warranty on this charger. This does not apply
to damages caused by: low quality batteries leaking inside the char-
ger, non-compliance of the operating instruction or physical damage
due to lack of care.
Technical details subject to change without prior notice. No liability accepted for
typographical errors or omissions.
Deutsch |
Español | Nederlands | Svenska | Suomi
English
| Français
Publicidad
