PIAB PNP NO LM8 Manual De Instrucciones página 2

VACUUM SWITCH
WARNING
This caution mark indicates that there is a possibility that the
user may suffer from damage or that physical injury may occur if
the product is used improperly.
The product is neither drip-proof nor dust-proof design. Do not
use it under conditions where water or oil drips, dust rises or
corrosion occurs.
Do not use corrosive gases or liquids as pressure media.
Do not apply pressure exceeding the maximum allowable
pressure. Please see specifications.
Do not short-circuit the output terminal (switch terminal) to the
other terminals. Also, do not apply a load that would allow a
current that is higher than the rated current, as the internal cir-
cuitry may be damaged.
When handling the product, be sure to pick up the body and
not to apply excessive force to the cable.
When piping, do not use a wrench to any other part than the
port section, and tighten the fitting with a torque that is lower
than the specified torque.
When setting the pressure-setting trimmer, do not subject
them to too much force. The allowable torque for the pressure-
setting trimmer is no more than 0.02 Nm.
2