Getting Started; Standard Components; Inserting The Batteries; Telephone Connection - HumanTechnik scalla 2 Instrucciones De Servicio

Getting started

Standard components

Please check if all following components are
included:
• Telephone base unit
• Telephone receiver
• Receiver cord
• Telephone cable
• 4x 1,5V Batterien (Type "AAA")
• 7.5V plug-in PSU
• Speed-dial inlay card
• Operating instructions
• Warranty card
If any parts are missing please immediately
contact your dealer or the manufacturer di-
rectly.

Inserting the batteries

The telephone requires four 1.5V batteries
("AAA") to operate the display.
To insert the batteries, proceed as follows:
1. Remove the battery compartment cover
from the bottom side of the telephone.
2. Now insert four 1.5V batteries ("AAA")
into the battery compartment. Make sure
that they are inserted correctly!
3. Replace the battery compartment cover.
Note: For the backlight in the display and the
telephone's special functions, you must also
connect the power cord (see "Telephone
connection").

Telephone connection

1. Insert the receiver cord (spiral-shaped
cable) into the jack marked with a recei-
ver symbol on the left side of the base
unit and into the receiver.
32 English
2. Insert the smaller plug (western plug) on
the telephone wire into the
panel). Insert the larger plug (TAE plug)
into the outlet for your telephone connec-
tion.
3. Insert the plug-in mains adapter cable into
the „DC 7.5V" jack. Plug the mains adapter
into a 230 V mains socket.
Warning!
Don't place the telephone close to tele-
visions, VDUs, fans, etc. so as to minimize
the risk of interference. Don't place the tele-
phone in direct sunlight or close to a source
of heat.
Only use the original telephone cable or a
comparable cable with an international con-
figuration.
jack (rear