Publicidad
Idiomas disponibles
Idiomas disponibles
8.8
Changing between logs and
crystals
WARNING
Risk of burns!
» Some parts of this product can
become very hot and cause burns�
Make sure the product has cooled
down and/or off before changing the
logs and crystals�
Change the look of the product by removing
the installed logs (B) behind the display
panel (A)�
1� Remove the display panel (A) as
described in installation B step 1�
2� Continue with the below 2 steps to
remove the screws and logs, then place
the crystals (C) along the display edge
evenly�
1
x 2
2
C
9. Changing the Battery
1� Remove the battery holder from the
remote control�
2� Replace the used battery with a new
CR2025 3 V battery� The positive pole (+)
must be pointing upwards�
2
1
4
10. Cleaning and Maintenance
WARNING
Risk of electric shock!
To prevent electric shock:
For wall installation A: Set the power
switch (F) to '0' and remove the plug (G)
from the socket outlet�
For recessed installation B and C: Set
the wall switch to off�
10.1
Cleaning
NOTICE
Clean the product regularly
to prevent the build-up of hairs dust or lint
around the heating vents (C), as this may
cause the outlet to become blocked�
» To clean the product, wipe with a soft,
slightly moist cloth�
» Never use corrosive detergents, wire
brushes, abrasive scourers, metal or
sharp utensils to clean the product�
» Do not spray liquids directly onto any
surfaces of the product�
EN
3
5
13
Publicidad
