Publicidad
Idiomas disponibles
Idiomas disponibles
˜ LED behaviour table
Power
ON/OFF
Power ON
Power OFF
˜ Establishing a Bluetooth
Remove all plugs from the AUX-in jack 3 before you attempt to
establish a Bluetooth
Switch on the playback device and make sures its Bluetooth
is on.
On the product press the
LED 7 flashes white and a signal tone sequence sounds. The
product will now attempt to connect to the playback device (e.g.
smartphone or computer).
The product identification on the playback device will be
"RHYTHM BLAST". On the playback device "ACCEPT" the
connection. Please note the requirements of the software on the
playback device.
Once the connection is made the LED 7 flashes white once every
5 seconds and a signal tone sequence sounds.
The maximum range of the connection is approx. 10 m,
but this may be reduced due to the geometry of the space
(obstructing furniture, walls, etc.).
The playback device must support Bluetooth
otherwise you may not be able to use all the functions.
28 GB/IE
Status
LED color
Power ON
LED flashes once per sec. white
Bluetooth
Bluetooth pairing mode: LED flashes
connection
once per sec. white
Bluetooth paired: After Bluetooth
pairing, the LED flashes white approx.
every 5 sec.
TWS
TWS primary unit:LED flashes
connection
approximately every 5 seconds white
Secondary unit: LED soild white
PartyPlay
Primary unit:LED soild white
connection
Other unit:LED breathing white
AUX
Solid green
connection
Charging
A light bar lights up to display the
battery capacity level 25%-50%-75%-
100% respectively
Low battery
LED flashes white
Charging
A light bar lights up to display the
battery capacity level 25%-50%-75%-
100% respectively
connection.
®
connection:
®
button 9 for 2 seconds until the
standard 5.3
®
mode
®
Publicidad
