DJI C10000 Guía De Usuario página 7

Activation
The intelligent power supply must be activated before using for the first time. Connect the remote
controller to the internet first. Use a USB-C cable to connect to the USB-C connector of the power
supply and the USB-A connector of the remote controller. Run the DJI Agras app on the remote
controller and tap Device Management > Charging Device to activate the power supply.
Using the Intelligent Power Supply
The C10000 Intelligent Power Supply supports both fast and slow charging. Different power cables are
required to connect to qualified power supplies when using different charging methods.
Fast Charging Method 1: Use two fast charging cables to connect the power supply to a three-phase-
five-wire industrial power supply that has a rated output of 18 kW or above.
Fast Charging Method 2: Use two fast charging cables to connect the power supply to a third-party
single-phase generator that has a rated voltage of 220 V and rated output of 12 kW or above.
• To use the power supply with a third-party generator for fast charging, connect the hot wires
(labeled L), neutral wires (labeled N), and ground wires (labeled PE) of the power supply to
a hot terminal, neutral terminals, and ground terminals of the generator respectively. Make
sure to connect the two hot wires to the same hot terminal. Refer to the user manual of the
generator for other specific usages.
Slow Charging: Use a slow charging cable with the conversion cable to connect the power supply to a
power outlet.
The following will describe the detailed steps of charging the intelligent flight battery using fast
charging (take fast charging method 1 as an example) and slow charging.
Fast Charging
1. Turn off the air circuit breaker for the three-phase AC power supply.
2. Take out the safety pins from the fast charging cables, connect the cables to the power supply, and
insert the safety pins back in place.
• After connecting the fast charging cables to the power supply, make sure to insert the safety
pins back into place to avoid damage caused by a loose connector.
1
3. Connect the two fast charging cables to a three-phase-five-wire industrial power supply:
Connect the hot wires (labeled L), neutral wires (labeled N), and ground wires (labeled PE) of the
fast charging cables to the hot terminals, neutral terminal, and ground terminal of the three-phase
power supply, respectively. Make sure to connect the two hot wires to different hot terminals.
• Only qualified electricians wearing insulated gloves can perform the fast charging connection.
• When using the fast charging connection, the input current required by the power supply
exceeds 16A. DO NOT connect the fast charging cables to 16A or 10A power outlets.
2
3
5