Publicidad
Idiomas disponibles
Idiomas disponibles
4. Turn on the air circuit breaker of the three-phase AC power supply.
5. Connect the power supply to the battery. To charge the DB1560/T40 Intelligent Flight Battery,
connect the charging cable to the air-cooled heat sink before putting the battery into the heat sink.
The power supply starts to charge the battery. The four LEDs of the battery blink in sequence while
charging. Remove the battery when the four LEDs turn solid or off and put another battery inside
the heat sink to charge.
6. When charging is finished, turn off the air circuit breaker before disconnecting the fast charging
cables from the power supply.
Slow Charging
• The type of the power outlet may vary depending on the country or region. Choose the
appropriate power outlet accordingly.
• DO NOT use two slow charging cables simultaneously indoors.
1. Take out the safety pins from the conversion cable, connect the conversion cable to the main AC
power port of the power supply, and insert the safety pins back in place.
• After connecting the conversion cable to the power supply, make sure to insert the safety pins
back into place to avoid damage caused by a loose connector.
1
6
2
L
L
N
Hot Wire
Ground Wire
Hot Wire
Neutral Wire
1
1
PE
2
2
4
3
3
Publicidad
