Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Problem
Possible cause
The surface
The control knob is not
burners do not
set properly.
light.
The burner caps are not
in place.
The burner base is
misaligned.
A surface
The control knob has
burner
been left in the Lite
clicks during
position.
operation.
The burners do
The surface burner
not burn evenly.
components and caps
are not assembled
correctly and level.
The surface burners are
dirty.
Very large or
The wrong burner orifice
yellow surface
is installed.
burner flames.
The surface
The oven door lock is
burners light
turned on.
but the oven
burners do not
light.
The Gas Pressure
Regulator shut off switch
is in the off position.
44 English
Action
Push in the control knob and turn
it to the Lite position.
Clean the electrodes.
Put the burner cap on the burner
head.
Align the burner base.
After the burner lights, turn the
control knob to a desired setting.
If the burner still clicks, contact a
service technician.
See page 39.
Clean surface burner components.
(See page 39.)
Check the burner orifice size.
Contact your installer if you have
the wrong orifice (LP gas instead
of natural gas or natural gas
instead of LP gas).
The display will show the Lock
icon. Hold the oven door open
and press the START/SET pad for
3 seconds. The oven will beep and
the Lock icon will turn off.
Call a qualified service technician.
Oven
Problem
Possible cause
The oven
There may be a
control beeps
malfunction. See the
and displays
"Information codes" chart
an information
on page 47.
code.
Very large or
The oven burner air
yellow oven
adjustment shutters
burner flames.
need to be adjusted.
The gas supply is not
properly connected or
turned on.
The oven
Oven thermostat needs
temperature is
adjustment.
too hot or cold.
An oven burner
The oven door lock is
will not shut off.
turned on.
The Sabbath function
has been activated.
Action
Press the OVEN OFF pad, and then
restart the oven.
If the problem persists, disconnect
all power to the range for at least
30 seconds and then reconnect
the power. If this does not solve
the problem, call for service.
Call for a qualified service
technician.
See the Installation Instructions
that came with your range.
See page 32.
The display will show the Lock
icon. Hold the oven door open
and press the START/SET pad for
3 seconds. The oven will beep and
the Lock icon will turn off.
SAb and the time of day will show
in the display. All other controls
and signals will be deactivated. To
turn off the oven only, press the
OVEN OFF pad.
To cancel the Sabbath function and
reactivate the controls and signals,
press and hold the Bake and the
Number 1 pads simultaneously for
3 seconds.
Publicidad
