Publicidad
Idiomas disponibles
Idiomas disponibles
5
After making sure that there are no water droplets or foreign
particles on the O-ring, close the waterproof case and turn the
open/close knob in the direction of "CLOSE" arrow to seal it tight.
Wash it thoroughly with fresh water once again.
6
Carefully wipe off the water droplets from the waterproof case.
7
Open the waterproof case a little and dry it in a breezy place out
of direct sunlight. After drying the case, store it where it will not
be directly exposed to sunlight.
If the waterproof case is not to be used for a long time, remove the O-ring
and store the waterproof case safely. For how to remove the O-ring, see
p.22.
Try to remove any remaining salt by
lightly moving the various buttons
under the water.
We recommend soaking it in fresh
water for about 1 hour.
If stored with drops of salty water
on it, salt crystals will clog the
movement of the open/close knob
and other parts. Rusting may also be
caused.
When closing the waterproof case,
take care not to catch your fingers or
palm in the waterproof case.
Use a soft, lint-free piece of cloth or
something similar.
Remove the water droplets from
under the Shutter lever, the open/
close knob and the others.
Do not use a hair dryer, warm or
hot air, or direct sunlight to dry the
waterproof case.
EN-21
Publicidad
