broda Rocker 48R Manual De Operaciones página 15

3.7 Adjustable Seat Height
The seat to floor height is adjustable to allow for proper
"foot on floor" position for foot propulsion.
To Adjust the Seat Height:
-Using 7/16 wrenches, remove the bolts.
-Raise or lower the front of the seat to correspond with
the holes at the desired seat height.
- Insert the bolts through the desired corresponding holes
and tighten the bolts.
Changing the seat height on the Latitude Pedal Chair
may affect the range of seat tilt as only the front of the
seat is being raised. If desired, a PAB Length
Adjustment Bar may be used on the tilt cylinder to
maintain the original range of tilt.
3.8 PAB BAR (Optional)
The PAB BAR may be used to maintain the original
range of tilt when the seat height has been adjusted.
-Remove the bolts and spacers from the top of the
cylinder.
-Slide the PAB Bar over top of the cylinder.
-Determine the height for the PAB BAR and insert a
2 ¼" bolt through the appropriate hole. After inserting
the bolt, place 2 spacers- (1/2" and 3/8") before
inserting the bolt through the cylinder.
-Insert the bolt through the cylinder and secure. Attach
the top portion of the PAB BAR to the chair back.
2
13
2
1
1